GPS NEO-6M Shield GPS Record Module With SD Interface For Arduino

Introduction

It is based on the NEO-6 u blox 6 GPS module and is pin compatible with Arduino/MEGA boards. The regular GPS pin (RX, TX) can be connected to the Ddu-D7 of the Arduino. Multiple GPS receivers are easily mounted on the expansion board, and you can find your exact location within a few meters. At the same time GPS also provides you with very accurate time! It can be used in car navigation, personal positioning, fleet management, navigation and navigation.

characteristic

1. Use an active GPS antenna.

2. TxD and RxD can be set by jumper to connect to the Ardino pin (D0-D8 is optional). The default position of the jumper cap is D2<-->RX, D3<-->TX.

3, TF deck, SPI interface. Support for Arduino libraries.

4. With the reset button, you can directly reset the Arduino backplane.